Google translation
Language :
EnglishFrenchSpainGermanChineseJapaneseItalianPortuguese

Sunlite Suite

Manual
Choose your manual : Sunlite Suite | Sunlite Suite 2 | Magic 3D Easy View | Easy Show | Hardware | ScanLibrary Editor
Top > Sunlite Suite > General settings > Setting up multiple DMX universes
Next
Previous

Sunlite Suite

Setting up multiple DMX universes

The software can control up to 50 DMX universes simultaneously. The different universes can be sent with our electronic interfaces (USB or IP) or with the ethernet connector of the computer (Art-Net protocol). It is important to understand how to setup the multiple universes in order to send the DMX information to the correct output. We will see in the following chapter how to setup and use multiple DMX universes with your software.

Using the USB interfaces
Sunlite can operate up to 10 USB-DMX interfaces simultaneously. Then, it is possible to run 10 DMX universes with single output interfaces and 20 universes with new IN/OUT interfaces. We will see later how to convert the DMX IN connector of your...
Using the IP interfaces
To use the IP interface you must first make sure that your IP interface is connected and configured correctly, and recognized by the network and the computer which will control your lights.  Refer to the Appendix "IP/Ethernet configuration" for...
Using the Art-Net protocol
To use the Art-Net protocol first make sure that you have an interface connected to your computer.  Art-Net protocol will not work unless you have an interface connected which will unlock this feature.  Connect your fixture using your computers...

Copyright © 2013 ~ Nicolaudie. All rights reserved.