Hardware

USB-DMX interfaces 512 channels

The USB standard defines a new type of serial-communication as well as a new type of connector. This standard was introduced in 1997 and has been spreading ever since 1999.
It offers many advantages in...

The USB interface is set and ready to use. When using one for the first time, it is necessary for the USB drivers to be installed. These are the files required to use the interface and will be installed inside your PC,...

Role played by the 3 Leds on the interface

· The yellow Led (in the middle) indicates that the interface is properly-powered.

· The red Led situated by the "DMX" connector blinks to indicate that the DMX signal is being sent. No...

The stand alone memory capacity depends on the number of channels. The more channels you use, the less steps are available.

See the following table to know the number of steps available.
The "IP version" column shows the memory capacity...

Here are the characteristics of the external power supply for the "stand alone" interfaces:
Voltage: between 9V and 12V DC
Intensity: 300mA or more
Polarity: + in the centre

We advise a power supply respecting the CE and UL...

The "stand alone" interfaces have 2 HE10 connectors.

The external "I/O ports" connector. This enables you to connect 8 ports. No power is needed, you only have to make a temporary contact between the ground (pin 2) and one of the 8 ports...

If your interface is recognized by the software and there is no DMX output from the interface, this problem can be fixed by simply replacing the DMX chip, which users can do themselves very easily.
Note: The "DMX chip" is an 8 pin...

The "DMX" norm imposes 5-pin XLR but the use of 3-pin XLR is very widespread because of their cost. Our interfaces are available either in 3-pin or 5-pin. You can change the XLR connector if you want. To do so, there are 4 resistors (0 ohms). See...

Please read carefully the following preventive measures:

1. Place a DMX insulator between interface and DMX fixtures (e.g. Botex DD2, Elation DMX Branch/4) in order to protect them both from any interference and from overvoltage....

SYMPTOMS
CAUSES
REMEDIES

Software cannot find USB interface

USB cable is not connected properly or USB port is faulty

"Intelligent USB DMX Interface" is not mentioned in list of devices : driver is not...