Hardware

Hardware

How to use as Artnet-to-DMX converter

Use of SLESA-IP1 interface as Art-Net to DMX converter

Here is the procedure which enables you to setup the converter:

1 - Hold button #3 (near the '+' and '-' buttons) while the interface is being turned ON
2 - The green and red led flash simultaneously for a few seconds
3 - The decoder mode is now enabled
4 - To know the universe, hold button #3 and the green led shows the universe # being decoded (1 flash means universe #1, 2 flashes mean universe #2...)
5 - The universe can be changed using the '+' and '-' buttons

Note: Restarting the interface while holding the button #3, disables the decoder mode.

Copyright © 2013 ~ Nicolaudie. All rights reserved.