magic 3d with jands vista2
Moderators: simonB, nick, dylan, RichterMC, florent, Ben
-
- New Forumor
- Posts: 12
- Joined: Fri Sep 02, 2011 9:07 pm
magic 3d with jands vista2
Hi there, I own a sunlite suite2-FC and i'm trying to work with magic 3d easy view controlled by jands vista2 software as a controller but the two software don't comunicate by artnet. I don't know if i'm doing something wrong in the artnet connections or it's impossible to work magic 3d with jands vista2. thanks everybody for an answer!
Re: magic 3d with jands vista2
Hi There, normally this should work fine
-Be sure you have no other DMX software open, just EasyView
-Check that the artnet universes are set up correctly in the Universes window of EasyView
-Check that the IP address settings are correct on your computers ethernet card
-Be sure you have no other DMX software open, just EasyView
-Check that the artnet universes are set up correctly in the Universes window of EasyView
-Check that the IP address settings are correct on your computers ethernet card
Simon
--
Sales/Support
--
Sales/Support